Schwinn How to ensure console working properly

Sep 22, 2021

How to Check Battery Levels:
1) Turn on console, enter service mode, and scroll to the “AP-“ menu
2) Tap backlight button, middle display will flash “AP0”, bottom left will read “Consl” and top left will display a number – that number is the percentage of battery life remaining in the console batteries
3) Scroll to “AP1”, top left is % battery life for speed sensor
4) Scroll to “AP2”, top left is % battery life for power sensor
5) Any battery below 20% should be replaced
HIGHLY RECOMMENDED: when you have a battery that needs to be replaced, replace that same battery on all bikes in your room – e.g. if a power sensor battery is low and needs to be changed, change ALL the power sensor batteries in the room
6) NOTE: the console percentage reading of battery life does not always re-set right away – you might put in a new battery but the console readout will still show the low percentage of the old battery – this is a bug in the system, but if the battery
has full power, the system will work even if the battery indicator shows low

How to Change between Km and Miles:
1) Push any button to turn on console
2) Hold down "Stage" and "Avg/End" buttons for 5 seconds to enter service mode
3) Tap “Avg/End” button until middle display reads “Un-“
4) Tap backlight button, middle display will be flashing “Un0”
5) Tap “Avg/End” button, middle display will be flashing “Un1”
6) Tap backlight, top right display will read “Un1” and top left will read “MPH”
a. Tap “Avg/End” button until middle display flashes “---“
7) Tap backlight to exit service mode
8) NOTE: to set to metric, Tap backlight with “Un0” flashing in the middle display